DIY Asbestos Removal - Removal of Non Friable Asbestos

Non friable asbestos can be extremely difficult to identify. The only path to be sure that the material you are coping with is asbestos is always to take an example of the material and send it into a lab for analysis. That is also a good way to prove that a material doesn't contain asbestos.

 A rule of thumb in Australia is if a material is suspected to be asbestos then treat it as although it contains asbestos.Non friable asbestos is essentially asbestos combined with another material. Non friable implies that the material is not able to be crumbled into dust by hand pressure. 

Samples of asbestos products that could be classified as non friable are asbestos roofs and asbestos walls.Types of asbestos products which can be classified as friable could be asbestos ropes and asbestos insulation.

 

Too safely remove non friable asbestos you need to check out these procedures.Never separation or smash an asbestos product this may release asbestos.

When removing always wet the material down either with water as well as better spray a remedy of PVA glue onto the material.If nails or screws are holding the material set up carefully eliminate the nails by nail puller, cold chisel or flooring spike.

A nail puller will pull the nail out a cold chisel will need the top of the nail and a flooring spike can be used to push the nail back. I find the more expensive nails are better removed with the nail puller and smaller nails with a flooring spike. 

 Screws or bolts are to be removed yourself powered tools, electric powered tools are not recommended because of the potential to damage the asbestos.

 

Personal protective web equipment to be used includes disposable overalls, gloves and a P2 rated respirator. Overalls and gloves are thrown out after every use. Respirators can be utilized again, only if they're a reusable type. 

The respirator ought to be the first device you add on and the past device to take off.When working indoors with asbestos the area in which you work must be sealed off. This really is to avoid the spread of asbestos dust into the rest of the building. 

You are able to do this with some builders plastic and duct tape.Once you have finished removing asbestos its time to clean up. For this you will require a HEPA vacuum that's a.3 micron filter. Vacuum all floors and walls thoroughly. 

Once vacuumed you can defeat all the plastic. Dump the plastic as asbestos waste. Your room should now be safe for human habitation again.